National Oilwell Varco
Machine Operator at National Oilwell Varco is responsible for the manufacturing of Power Section (Stator & Rotor) by following procedures and SOP. Aspirants meeting the eligibility requirements are encouraged to apply. Job ID for this vacancy is 28168.
Responsibilities Of Machine Operator
- Manufacturing Stators and Rotors for usage in oilfield directional drilling.
- Follow procedures related to stator and rotor manufacturing process.
- Review of the necessary manufacturing procedures frequency to be fluent and aware of the critical parameters related to the process.
- Verify quality control checks at each manufacturing process, prior to planning or transferring the job to the next process of manufacturing.
- Support and participate in the Organizations Continual Improvement program and any problem-solving initiatives.
- Follow the operating procedures (SOP) and perform the task based on the Job Hazard analysis performed.
- Operation of overhead cranes in the movement of parts or products.
- Report any abnormalities or variations observed in the manufacturing process to the concerned parties.
- Ensure the tools, gauges and equipment’s used in manufacturing are maintained properly.
- Document and maintain checklist, paper routers, or any ERP system that are in place.
- Assist and support in the repair work of any machine or areas in the facility.
- Handling of products, tubes & core at elevated temperatures by following the necessary safety procedures.
- Follow the house keeping as per the 5S requirements.
- Suggest or raise observation on any improvements, risk, safety concerns and good practices.
- Ensure to comply with all NOV HSE procedures and policies and maintain relevant HSE logs.
What You Will Do More As A Machine Operator
- Observe HSE regulations, encourages safe working practices, corrects obvious hazards immediately or reports them to the proper personnel.
- Perform daily operator checklist of machines.
- Knowledge of the proper use of measuring tools/gauge and tools.
- Understand routers, drawings and procedures.
- Able to communicate in English (both writing and orally).
- Understanding of pneumatic, hydraulic, basic electrical systems and with mechanical aptitude.
- Experience in safe use of power tools used in Manufacturing Industries.
- Capture/measure necessary process parameters and record the readings.
- Ensure controlled use of elastomer & chemicals issued to shop floor.
- Check the stator or rotor prior to starting any process and report if in doubt.
- Ensure the stator/rotor is processed to the next step only after complete review of task performed.
- Ensure machines are running as per the requirement.
- Operate Boiler, Generator, Air compressors, Forklift (License / Certification required) when needs/advised.
- Assist maintenance technicians when critical machine breakdowns are been attended.
- Provide training to any new hire / operators that are under the certification program.
- Other duties, as assigned by the supervisor.
Desired Skills & Competencies
- Ability to understand basic engineering drawings.
- Ability to present and explain basic technical information to diverse audience.
- Ability to document, store and retrieve information as per basic QMS.
Eligibility Requirements
The minimum requirements for the role of Machine Operator are as under:
- High School Diploma or equivalent with knowledge in basic math.